IP Audio Encoder/Decoder

TERRA-IEX2II

  • - 2 balanced Mic/line inputs
  • - 1 stereo or 2 mono line output with 3.81 mm Euro-block
  • - 1 headphone output (3.5 mm mini-jack)
  • - 3 logic contact inputs and 1 contact output
  • - Easily configured, controlled, managed and monitored via web browser
  • - Internal 200MB storage and micro-SD card interface for music/message recording storage
  • IP Audio Encoder/Decoder (0)
  • IP Audio Encoder/Decoder (1)
  • IP Audio Encoder/Decoder (2)
  • IP Audio Encoder/Decoder (3)
  • IP Audio Encoder/Decoder (4)
  • IP Audio Encoder/Decoder (5)

TERRA-IEX2II is designed for simple point-to-point or point-to-multi-point audio distribution, as well as converting analog audio via an Ethernet/Internet network without the need for a computer. TERRA-lEX2II incorporates a high-quality MP3 encoder and decoder. The decoder converts MP3 audio from the network, and the encoder converts analog audio sources, such as a CD player, to the network. The internal memory of TERRA-lEX2II supports up to 200MB for music/messages/recordings storage. Audio files can be easily stored through a computer on the local network and played locally. Additionally, the micro-SD card can store all audio files.

The typical application involves integrating BGM playback and emergency calls using a single TERRA-lEX2II. Generally, the TERRA-lEX2II is utilized for decoding MP3 audio streaming from the network. A push button is connected to the control input of TERRA-lEX2II for emergency calls. Additionally, users can connect an external microphone* of their choice to the mic input. Lastly, users can program one or several target IP addresses through the TERRA-IEX2II web browser. When the push button is pressed, BGM playback automatically stops, and the emergency call is triggered to play to the pre-programmed target or to multiple targets sequentially as programmed. The call can be a live broadcast or predefined messages.

Models:

  • TERRA-IEX2II: IP Audio Encoder/Decoder II (RS232)

Electrical

  • Power over Ethernet (PoE+)
  • DC power input: 21 ~ 27.5 VDC
  • Power consumption
    • PoE+: 25W max.
    • External power: 50W max.
    • Stand-by: 3W
  • Input power option: DC power input, PoE (IEEE 802.3 af ), PoE+ (IEEE 802.3at)

Audio Characteristics (MIC INPUT)

  • Phantom power: 24 VDC
  • Frequency response: 20 Hz ~ 20 kHz (±1 dB) @ 0 dBu
  • Input impedance (balanced): 5.5k ohm
  • EIN (Equivalent Input Noise): < 85 dB @ 14 dBu
  • THD+N: < 0.1 % (20 ~ 20 kHz @ 0 dBu)

Interconnection

  • Female RJ45 socket, CAT5/6 cables
  • Max. cable length: 100m

Supported Protocols

  • SIP 2.0 (peer and proxy)
  • IETF SIP (RFC3261)
  • IETF IGMP version 2 (RFC2236)
  • IETF RTP (RFC1889)
  • Switch requirements (minimum request)
    • Transmission rate: 10/100M bps
    • Communication mode: full-duplex
    • IP protocols: IPv4, TCP/IP

Contact Output

  • Default status: OPEN (N.O.)
  • Maximum voltage: 30 VDC
  • Maximum current: 1A

Network

  • 10/100 Mbps Base TX Ethernet RJ45
  • Manual or Dynamic Host Configuration Protocol (DHCP) IP address setup

Mechanical

  • Dimensions (W x H x D): 105 x 32 x 83 mm 
  • Weight: 340g 

Environmental

  • Operating temperature: -5 ºC ~ +50 ºC 
  • Storage temperature: -40 ºC ~ +70 ºC 
  • Relative humidity: 20% to 95%
  • Air pressure: 600 to 1100 hPa
  • Heat dissipation: 10.24 BTU/hr @ 20 W x 2 CH
Type File Name Download
Datasheet
[PDF] TERRA-IEXII_datasheet
Type File Name Download
Fiche produit
[PDF] TERRA-IEXII_Fiche Produit
Type File Name Download
Datenblatt
[PDF] TERRA-IEXII_Datenblatt

Related products